VEHICLE STABILITY CONTROL SYSTEM Slip Indicator Light does not Come ON
| DTC Code | DTC Name |
|---|---|
| Slip Indicator Light does not Come ON |
DESCRIPTION
Refer to Slip Indicator Light Remains ON (Click here).
WIRING DIAGRAM
Refer to Slip Indicator Light Remains ON (Click here).
CAUTION / NOTICE / HINT
When replacing the skid control ECU (brake actuator assembly), perform system variant learning and acceleration sensor zero point calibration (Click here).
PROCEDURE
CHECK CAN COMMUNICATION SYSTEM
PERFORM ACTIVE TEST USING GTS (SLIP INDICATOR LIGHT)
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Select the Active Test on the GTS (Click here).
Table 1. ABS/VSC/TRC Tester Display
Test Part
Control Range
Diagnostic Note
Slip Indicator Light
Slip indicator light
Indicator light ON/OFF
Can be observed on the combination meter assembly
Vehicle condition: Vehicle stopped
Select the Data List on the GTS (Click here).
Table 2. ABS/VSC/TRC Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Slip Indicator Light
Slip indicator light/ ON or OFF
ON: Indicator light on
OFF: Indicator light off
-
Check the operating condition of the slip indicator light when operating it using the GTS.
Result
Result
Proceed to
Slip Indicator Light in the Data List does not change using the Active Test.
A
Slip Indicator Light in the Data List turns ON/OFF using the Active Test.
B
INSPECT COMBINATION METER ASSEMBLY
Turn the ignition switch off.
Perform an Active Test of the combination meter assembly using the GTS (Click here).
Check the combination meter assembly.
OK
The slip indicator light turns on or off in accordance with the Active Test operation.