FRONT DOOR SPEAKER INSPECTION

PROCEDURE

  1. INSPECT FRONT NO. 1 SPEAKER ASSEMBLY

    1. With the speaker installed, check that there is no looseness or other abnormalities.

    2. Check that there is no foreign matter in the speaker, no tears on the speaker cone or other abnormalities.

    3. E219303C03

      *a

      Component without harness connected

      (Front No. 1 Speaker Assembly)

      Measure the resistance of the speaker.

      Standard Resistance

      Table 1. except 9 Speakers

      Tester Connection

      Condition

      Specified Condition

      1 - 2

      Always

      3.2 to 4.8 Ω
      Table 2. for 9 Speakers

      Tester Connection

      Condition

      Specified Condition

      1 - 2

      Always

      3.2 to 5.2 Ω

      If the result is not as specified, replace the speaker.

  2. INSPECT INSPECT FRONT NO. 2 SPEAKER ASSEMBLY (except 9 Speakers)

    1. With the speaker installed, check that there is no looseness or other abnormalities.

    2. Check that there is no foreign matter in the speaker, no tears on the speaker cone or other abnormalities.

    3. E226097C16

      *A

      for RH

      *B

      for LH

      *a

      Component without harness connected

      (Front No. 2 Speaker Assembly)

      Measure the resistance of the speaker.

      Standard Resistance

      Table 3. for RH

      Tester Connection

      Condition

      Specified Condition

      4 (TWR+) - 2 (TWR-)

      Always

      10 kΩ or higher

      1 (-) - 2 (TWR-)

      Always

      Below 1 Ω

      3 (+) - 4 (TWR+)

      Always

      Below 1 Ω
      Table 4. for LH

      Tester Connection

      Condition

      Specified Condition

      4 (TWL+) - 2 (TWL-)

      Always

      10 kΩ or higher

      1 (-) - 2 (TWL-)

      Always

      Below 1 Ω

      3 (+) - 4 (TWL+)

      Always

      Below 1 Ω

      If the result is not as specified, replace the speaker.

    4. When there is a possibility that either the right or left speaker is malfunctioning, interchange the speakers and perform an inspection. If the malfunction disappears after interchanging the speakers, replace the malfunctioning speaker.

      Tip:

      Connect all connectors to the speakers when performing an inspection. If the result is not as specified, replace the speaker.

  3. INSPECT FRONT NO. 2 SPEAKER ASSEMBLY (for 9 Speakers)

    1. With the speaker installed, check that there is no looseness or other abnormalities.

    2. Check that there is no foreign matter in the speaker, no tears on the speaker cone or other abnormalities.

    3. E226097C12

      *a

      Component without harness connected

      (Front No. 2 Speaker Assembly)

      Measure the resistance of the speaker.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      4 - 2

      Always

      10 kΩ or higher

      If the result is not as specified, replace the speaker.

    4. When there is a possibility that either the right or left speaker is malfunctioning, interchange the speakers and perform an inspection. If the malfunction disappears after interchanging the speakers, replace the malfunctioning speaker.

      Tip:

      Connect all connectors to the speakers when performing an inspection. If the result is not as specified, replace the speaker.