MULTI-MODE MANUAL TRANSAXLE UNIT COMPONENTS
ILLUSTRATION
*1 |
CLUTCH RELEASE BEARING ASSEMBLY |
*2 |
CLUTCH RELEASE FORK LEVER |
*3 |
CLUTCH RELEASE FORK LEVER SHAFT OIL SEAL |
*4 |
FRONT DIFFERENTIAL CASE |
*5 |
FRONT DIFFERENTIAL CASE FRONT TAPERED ROLLER BEARING (OUTER RACE) |
*6 |
FRONT DIFFERENTIAL CASE REAR TAPERED ROLLER BEARING (OUTER RACE) |
*7 |
FRONT DRIVE SHAFT OIL SEAL RH |
*8 |
FRONT OUTPUT SHAFT BEARING (OUTER RACE) |
*9 |
FRONT TRANSAXLE CASE OIL SEAL |
*10 |
INPUT SHAFT ASSEMBLY |
*11 |
OUTPUT SHAFT (MTM) COVER |
*12 |
OUTPUT SHAFT ASSEMBLY |
*13 |
REAR INPUT SHAFT BEARING SHIM |
*14 |
REAR OUTPUT SHAFT BEARING (OUTER RACE) |
*15 |
REAR OUTPUT SHAFT BEARING SHIM |
*16 |
TRANSMISSION MAGNET |
*17 |
CLUTCH RELEASE FORK |
*18 |
E-RING |
*19 |
MANUAL TRANSAXLE CASE PLUG |
*20 |
GASKET |
*21 |
DIFFERENTIAL CASE SHIM |
*22 |
NO. 1 CLUTCH HOUSING COVER |
*23 |
FRONT TRANSAXLE CASE |
- |
- |
 |
N*m (kgf*cm, ft.*lbf): Specified torque |
● |
Non-reusable part |
 |
MP grease |
- |
- |
ILLUSTRATION
*1 |
NO. 1 GEAR SHIFT FORK SHAFT |
*2 |
NO. 2 GEAR SHIFT FORK SHAFT |
*3 |
NO. 3 GEAR SHIFT FORK SHAFT |
*4 |
REVERSE IDLER GEAR SHAFT |
*5 |
REVERSE SHIFT ARM BRACKET ASSEMBLY |
*6 |
REVERSE IDLER GEAR SUB-ASSEMBLY |
*7 |
REVERSE SHIFT FORK |
*8 |
NO. 1 GEAR SHIFT FORK |
*9 |
NO. 2 GEAR SHIFT FORK |
*10 |
NO. 3 GEAR SHIFT FORK |
*11 |
NO. 1 GEAR SHIFT HEAD |
*12 |
NO. 3 GEAR SHIFT HEAD |
*13 |
COMPRESSION SPRING |
*14 |
SLOTTED SPRING PIN |
*15 |
STRAIGHT PIN |
*16 |
SNAP RING |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
● |
Non-reusable part |
★ |
Precoated part |
- |
- |
ILLUSTRATION
*1 |
BACK-UP LIGHT SWITCH ASSEMBLY |
*2 |
DRAIN PLUG |
*3 |
FILLER PLUG |
*4 |
FRONT DRIVE SHAFT OIL SEAL LH |
*5 |
MANUAL TRANSMISSION CASE |
*6 |
NO. 1 LOCK BALL ASSEMBLY |
*7 |
NO. 2 OIL RECEIVER PIPE (MTM) |
*8 |
PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
*9 |
REVERSE IDLER GEAR SHAFT BOLT |
*10 |
SHIFT AND SELECT ACTUATOR ASSEMBLY |
*11 |
TRANSMISSION REVOLUTION SENSOR |
*12 |
TRANSMISSION CASE PROTECTOR |
*13 |
GASKET |
*14 |
WIRE HARNESS CLAMP BRACKET |
*15 |
PLUG |
- |
- |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
● |
Non-reusable part |
|
MP grease |
 |
Adhesive 1324 |
 |
Adhesive 1344 |
★ |
Precoated part |