PRE-CRASH SAFETY SYSTEM


  1. OPERATION


    1. Warning Indication


      1. The combination meter assembly uses the multi-information display, master warning light, PCS warning light and buzzer to provide the driver with pre-crash safety system warnings and indications.

      2. If the driving support ECU assembly determines that there is a possibility of a collision is high, it sends a signal to the combination meter assembly. Upon receiving this signal, the combination meter assembly indicates a warning using the multi-information display, master warning light, PCS warning light and pre-crash safety city buzzer. Details are indicated below.

        When there is a high possibility of a collision
        Multi-information Display PCS Warning Light Pre-crash Safety City Buzzer
        BRAKE ! Flashes Sound Continuously

      3. The pre-crash safety system can be turn on and off through the setting screen on the multi-information display. When the pre-crash safety system is off, "Pre-Crash Safety System Turned Off" is displayed on the multi-information display and the PCS warning light illuminates.

        When the setting screen on the multi-information display is operated
        Multi-information Display PCS Warning Light Pre-crash Safety System
        - - ON
        Pre-Crash Safety System Turned Off Illuminates OFF

      4. When the system is not available, the following warning occurs to warn the driver.

        When a system malfunction is detected
        Multi-information Display Detail Master Warning Light PCS Warning Light Buzzer DTC

        Pre-Crash Safety System

        Malfunction

        Visit Your Dealer

        		 This message appears when the driving support ECU assembly detects a system malfunction. Illuminates Flashes Sounds once Repair is required and DTCs are stored

        Pre-Crash Safety System

        Unavailable

        		 Millimeter wave radar sensor assembly is misaligned - Flashes - -

        Pre-Crash Safety System

        Unavailable

        Clean Radar

        		 Dirty center mark of upper radiator grille or millimeter wave radar sensor assembly - Flashes - -

        Front Camera Systems

        Unavailable

        Clean Windshield

        		 Dirty windshield glass over the forward recognition camera (pre-crash safety city sensor) - Flashes - -

        Front Camera Systems

        Unavailable

        Wait a Moment

        		 Temperature or power supply of forward recognition camera (pre-crash safety city sensor) is abnormality - Flashes - -

        VSC Turned Off

        Pre-Crash Safety Brake System

        Unavailable

        		 VSC and TRAC operation has not been disabled - Illuminates - -

    2. Changing settings of the pre-crash safety system


      1. To change the enabled or disabled of the pre-crash safety system using the multi-information display and the steering pad switch assembly (meter control switches), display the setting display screen.


        • On the setting display screen, select PCS icon and then press on Enter/Set switch on the steering pad switch assembly.

        • Select [PCS] and then press on Enter/Set switch the steering wheel. Each time is pressed, the system will be enabled/disabled.

          A01QFQPC01
          *a PCS warning Light *b Multi-information Display
          *c Steering Pad Switch Assembly *d Enter/Set Switch

      2. The pre-crash warning timing can be changed on setting display of the multi-information display.


        • On the setting display screen, select PCS icon and then press on Enter/Set switch on the steering pad switch assembly.

        • Select [Sensitivity] and then press on Enter/Set switch the steering wheel. Each time Enter/Set switch is pressed, operation timing (Far/Middle/Near) of the pre-crash safety system will be changed.

          A01QF44C01
          *a Multi-information Display *b Far
          *c Middle *d Near
          *e Steering Pad Switch Assembly *f Enter/Set Switch