REAR AXLE HUB BOLT REPLACEMENT

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE

  1. REMOVE REAR WHEEL

  2. DISCONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH

    Click hereClick here

  3. REMOVE REAR DISC

    Click hereClick here

  4. REMOVE REAR AXLE HUB BOLT LH

    C229038C01

    *1

    Nut

    *a

    Hold

    *b

    Turn

    1. Temporarily install 2 nuts and 2 washers to the rear axle hub bolt as shown in the illustration.

    2. Using SST and a brass bar or an equivalent tool to hold the hub and bearing assembly, remove the rear axle hub bolt.

      09611-12010

  5. INSTALL REAR AXLE HUB BOLT LH

    C228495C01

    *1

    Washer

    *2

    Nut

    *a

    Hold

    *b

    Turn

    1. Install a washer and nut to a new rear axle hub bolt as shown in the illustration.

    2. Using a brass bar or an equivalent tool to hold the hub and bearing assembly, install the rear axle hub bolt by tightening the nut.

  6. INSTALL REAR DISC

    Click hereClick here

  7. CONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH

    Click hereClick here

  8. INSPECT AND ADJUST PARKING BRAKE

    Click here

  9. INSTALL REAR WHEEL

    103 N*m

    1050 kgf*cm

    76 ft.*lbf