PARK / NEUTRAL POSITION SWITCH INSTALLATION

PROCEDURE


  1. INSTALL PARK/NEUTRAL POSITION SWITCH


    1. Temporarily install the park/neutral position switch to the continuously variable transaxle with the 2 bolts.

    2. Install the lock nut and lock plate to the park/neutral position switch.

      Torque:
      6.9 N*m  { 70 kgf*cm, 61 in.*lbf }
    3. B008K9RN01

      Temporarily install the control shaft lever.

    4. Turn the control shaft lever clockwise until it stops, and then from that position turn it counterclockwise by 2 notches to set it to the N position.

    5. Remove the control shaft lever.

    6. B008KH8C08
      *a Neutral Basic Line
      *b Protrusion

      Align the protrusion with the neutral basic line.

    7. Hold the park/neutral position switch in that position and tighten the 2 bolts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }
    8. B008KKE

      Using a screwdriver, bend down the tabs of the lock plate.

    9. Install the control shaft lever to the continuously variable transaxle assembly with the nut and washer.

      Torque:
      12.7 N*m  { 130 kgf*cm, 9 ft.*lbf }

    10. Connect the park/neutral position switch connector.

  2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Connect the transmission control cable assembly to the No. 1 transmission control cable bracket with a new clip.

    2. Connect the transmission control cable assembly to the control shaft lever with the nut.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

      Note

      Before connecting the transmission control cable assembly, check that the park/neutral position switch and shift lever are in neutral.

  3. INSTALL BATTERY CLAMP SUB-ASSEMBLY

    Click here

  4. INSTALL ECM

    Click here

  5. INSTALL AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  6. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  7. INSTALL NO. 1 AIR CLEANER INLET

    Click here

  8. INSTALL RADIATOR COVER

    Click here

  9. INSTALL BATTERY

    Click here

  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  11. INSPECT SHIFT LEVER POSITION

    Click here

  12. ADJUST SHIFT LEVER POSITION

    Click here

  13. INSPECT PARK/NEUTRAL POSITION SWITCH

    Click here

  14. ADJUST PARK/NEUTRAL POSITION SWITCH

    Click here