HEATED OXYGEN SENSOR INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)

   

   *1	Fulcrum Length

   1. Using SST, install the heated oxygen sensor to the front No. 2 exhaust pipe sub-assembly.

      09224-00010

      without SST

      44 N*m

      449 kgf*cm

      32 ft.*lbf

      with SST

      40 N*m

      408 kgf*cm

      30 ft.*lbf

      Tip:

      • Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification.

        Click hereClick hereClick hereClick hereClick here

      • Make sure SST and the wrench are connected in a straight line.

      • w/ Canister Pump Module:

        Perform "Inspection After Repairs" after replacing the heated oxygen sensor.

        Click hereClick here

   2. Connect the heated oxygen sensor connector.

2. INSTALL FRONT NO. 2 EXHAUST PIPE SUB-ASSEMBLY

   1. Install a new gasket to the front No. 2 exhaust pipe sub-assembly.

   2. Install the front No. 2 exhaust pipe sub-assembly to the center exhaust pipe assembly with the 2 bolts.

      43 N*m

      438 kgf*cm

      32 ft.*lbf

3. INSTALL FRONT EXHAUST PIPE SUB-ASSEMBLY

   Click here

4. INSPECT FOR EXHAUST GAS LEAK

   Click here