ACCELERATOR PEDAL ON-VEHICLE INSPECTION

PROCEDURE

  1. CHECK ACCELERATOR PEDAL SENSOR ASSEMBLY

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS tester on.

    4. Enter the following menus: Powertrain / Engine and ECT / Data List / Accel Sens. No.1 Volt % and Accel Sens. No.2 Volt %.

      Powertrain > Engine > Data List

      Tester Display

      Accel Sens. No.1 Volt %

      Accel Sens. No.2 Volt %

    5. Operate the accelerator pedal sensor assembly and check that the "Accel Sens. No.1 Volt %" and "Accel Sens. No.2 Volt %" values are within the specification.

      Standard Voltage (Accel Sens. No.1 Volt %)

      Accelerator Pedal Condition

      Specified Condition

      Released

      10 to 22%

      Depressed

      52 to 90%

      Standard Voltage (Accel Sens. No.2 Volt %)

      Accelerator Pedal Condition

      Specified Condition

      Released

      24 to 40%

      Depressed

      68 to 95%

      If the result is not as specified, check the accelerator pedal sensor assembly, wire harness or ECM.