GLOW PLUG(w/ Glow Plug Controller) ON-VEHICLE INSPECTION

PROCEDURE

  1. INSPECT GLOW PLUG ASSEMBLY

    1. Remove the No. 1 glow plug connector.

      Click here

    2. A350458

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      Glow plug assembly terminal - Glow plug assembly body

      20°C (68°F)

      0.28 Ω or higher
      Note:

      • Do not damage the glow plug pipes as this could cause an open circuit or shorten the life of the glow plug assemblies.

      • Wipe any oil off the terminal and the Bakelite washer with a dry cloth if they are stained with oil during the inspection.

      If the result is not as specified, replace the glow plug assembly.

    3. Install the No. 1 glow plug connector.

      Click here