NAVIGATION SYSTEM(for Radio and Display Type) Vehicle Speed Signal Circuit between Radio Receiver and Extension Module

DTC Code DTC Name
Vehicle Speed Signal Circuit between Radio Receiver and Extension Module

DESCRIPTION

The navigation ECU receives a vehicle speed signal from the radio and display receiver assembly and information from the navigation antenna assembly, and then adjusts vehicle position.

WIRING DIAGRAM

E292618E02

CAUTION / NOTICE / HINT

Note:

Check that the wire harness is properly installed and does not have any sharp bends, pinching or loose connections.

Click hereClick here

PROCEDURE

  1. CHECK NO. 1 NAVIGATION WIRE (RADIO AND DISPLAY RECEIVER ASSEMBLY - NAVIGATION ECU)

    1. Disconnect the Y1 radio and display receiver assembly connector.

    2. Disconnect the Y5 navigation ECU connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      Y1-2 (SPDO) - Y5-5 (SPD)

      Always

      Below 1 Ω

      Y1-2 (SPDO) - Body ground

      Always

      10 kΩ or higher

    Result

    Proceed to

    OK

    NG
    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

    Click here

    NG

    REPLACE NO. 1 NAVIGATION WIRE

    Click here