MANUAL TRANSAXLE UNIT INSPECTION

PROCEDURE

  1. INSPECT REVERSE IDLER GEAR SUB-ASSEMBLY

    1. C200255

      Using a caliper gauge, measure the inside diameter of the reverse idler gear sub-assembly.

      Standard inside diameter

      20.056 to 20.074 mm (0.7897 to 0.7903 in.)

      Maximum inside diameter

      20.074 mm (0.7903 in.)

      If the inside diameter is more than the maximum, replace the reverse idler gear sub-assembly.

    2. Using a micrometer, measure the outer diameter of the reverse idler gear shaft.

      Standard outer diameter

      19.984 to 20.000 mm (0.7868 to 0.7874 in.)

      Minimum outer diameter

      19.984 mm (0.7868 in.)

      If the outer diameter is less than the minimum, replace the reverse idler gear shaft.