STEERING KNUCKLE(for AWD) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • The following procedure is for the LH side.

  • Other than areas where instructions are provided, use the same procedure for the LH and RH sides.

PROCEDURE


  1. INSTALL DISC BRAKE AIR GUIDE PLATE

    Click here

  2. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH

    Click here

  3. TEMPORARILY INSTALL STEERING KNUCKLE LH

    B006FF6

    1. Temporarily install the steering knuckle LH with the 3 bolts.

  4. CONNECT FRONT SUSPENSION UPPER ARM ASSEMBLY

    Click here

  5. TIGHTEN STEERING KNUCKLE LH

    B006FF6

    1. Tighten the steering knuckle LH with the 3 bolts.

      Torque:
      112.7 N*m  { 1149 kgf*cm, 83 ft.*lbf }

  6. CONNECT TIE ROD ASSEMBLY LH

    Click here

  7. INSTALL FRONT AXLE SHAFT NUT LH

    Click here

  8. INSTALL FRONT DISC BRAKE DUST COVER LH

    Click here

  9. INSPECT FRONT AXLE HUB BEARING LOOSENESS

    Click here

  10. INSPECT FRONT AXLE HUB RUNOUT

    Click here

  11. STAKE FRONT AXLE SHAFT NUT LH

    Click here

  12. INSTALL FRONT DISC LH


  13. CONNECT DISC BRAKE CYLINDER ASSEMBLY

    Click here

  14. CONNECT FRONT SPEED SENSOR LH

    Click here

  15. STABILIZE SUSPENSION

    Click here

  16. INSTALL STRUT BAR BRACKET SUPPORT SUB-ASSEMBLY

    Click here

  17. INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY

    Click here

  18. INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY

    Click here

  19. INSTALL FRONT WHEEL

    Click here

  20. CONNECT BRAKE BOOSTER PUMP CONNECTOR (w/o Vacuum Brake Booster)

    Click here

  21. CHECK FOR SPEED SENSOR SIGNAL


  22. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

    Click here

  23. INSPECT AND ADJUST VEHICLE HEIGHT (w/ Air Suspension)

    Click here

  24. PERFORM INITIALIZATION

    Parking support brake system

    Click here

    Panoramic view monitor system

    Click here

    Parking assist monitor system

    Click here

    Automatic headlight beam level control system

    Click here

  25. ADJUST HEADLIGHT AIMING

    Click here