НАСОС СИСТЕМЫ ОХЛАЖДЕНИЯ СНЯТИЕ

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the engine water pump assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Replacement of timing belt Mode reset operation

  • Does not illuminate when replacement is necessary

  • Illuminates when replacement is not necessary

Click here

CAUTION:

Do not remove the radiator cap sub-assembly, cylinder block water drain cock plug or radiator drain cock plug while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

B003Q6I

PROCEDURE


  1. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY

  2. DRAIN ENGINE COOLANT

    Click here

  3. REMOVE NO. 1 RADIATOR HOSE

    Click here

  4. DISCONNECT VANE PUMP OIL RESERVOIR ASSEMBLY

    Click here

  5. REMOVE OIL RESERVOIR BRACKET

    Click here

  6. REMOVE RADIATOR RESERVOIR

    Click here

  7. REMOVE FAN SHROUD

    Click here

  8. REMOVE TIMING BELT

    Click here

  9. REMOVE ENGINE WATER PUMP ASSEMBLY


    1. B003JIG

      Remove the 6 bolts and tension spring bracket.

    2. Remove the engine water pump assembly and gasket.