REAR AXLE CARRIER INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL REAR AXLE CARRIER SUB-ASSEMBLY LH


    1. Using a jack and wooden block, jack up the rear axle carrier sub-assembly LH to replicate the standard vehicle height conditions.

  2. TEMPORARILY TIGHTEN REAR UPPER CONTROL ARM ASSEMBLY LH


    1. A004J8V

      Temporarily tighten the rear upper control arm assembly LH to the rear axle carrier sub-assembly with the bolt and new nut.

  3. TEMPORARILY TIGHTEN REAR NO. 1 SUSPENSION ARM ASSEMBLY LH


    1. A004IF6

      Temporarily tighten the rear No. 1 suspension arm assembly LH to the rear axle carrier sub-assembly with the bolt and new nut.

  4. TEMPORARILY TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY LH


    1. A004JI3

      Temporarily tighten the rear No. 2 suspension arm assembly LH to the rear axle carrier sub-assembly with the bolt and new nut.

  5. INSTALL TOE CONTROL LINK SUB-ASSEMBLY LH


    1. Install the nut and the toe control link sub-assembly LH to the rear axle carrier sub-assembly.

      Torque:
      60 N*m  { 612 kgf*cm, 44 ft.*lbf }

    2. Install the cotter pin.

  6. TEMPORARILY TIGHTEN STABILIZER LINK SUB-ASSEMBLY (for LH Side)

    Click here

  7. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ HID Headlight System)

    Click here

  8. REMOVE NO. 3 PARKING BRAKE CABLE ASSEMBLY


    1. A004I0W

      Install the clip and the No. 3 parking brake cable assembly to the parking brake plate sub-assembly.

  9. REASSEMBLY PARKING BRAKE ASSEMBLY

    Click here

  10. STABILIZE SUSPENSION

    Click here

  11. FULLY TIGHTEN REAR UPPER CONTROL ARM ASSEMBLY LH


    1. A004J8V

      Fully tighten the bolt.

      Torque:
      80 N*m  { 816 kgf*cm, 59 ft.*lbf }

      Tech Tips

      Hold the bolt and tighten the nut.

  12. REMOVE REAR NO. 1 SUSPENSION ARM ASSEMBLY LH


    1. A004IF6

      Fully tighten the bolt.

      Torque:
      110 N*m  { 1122 kgf*cm, 81 ft.*lbf }

      Tech Tips

      Hold the bolt and tighten the nut.

  13. INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY LH


    1. A004JI3

      Fully tighten the bolt.

      Torque:
      80 N*m  { 816 kgf*cm, 59 ft.*lbf }

      Tech Tips

      Hold the bolt and tighten the nut.

  14. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY LH

    Click here

  15. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

    Click here

  16. VSC SENSOR NEUTRAL MEMORIZATION

    Click here

  17. HEIGHT CONTROL SENSOR SIGNAL INITIALIZE (w/ HID Headlight System)

    Click here

  18. ADJUST HID Headlight System (w/ HID Headlight System)

    Click here