DATA LIST
Tech Tips
Using the GTS to read the Data List allows the values or states of switches, sensors, actuator and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Note
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| IG SW | Ignition switch ON signal / ON or OFF | ON: Ignition switch ON OFF: Ignition switch off |
- |
| ACC SW | Ignition switch ACC signal / ON or OFF | ON: Ignition switch ACC OFF: Ignition switch off |
- |
| Dimmer SW | Dimmer switch high position signal / ON or OFF | ON: Dimmer switch in high or high flash position OFF: Dimmer switch in low position |
- |
| Passing Light SW | Dimmer switch high flash position (pass) signal / ON or OFF | ON: Dimmer switch in high flash position OFF: Dimmer switch not in high flash position |
- |
| Lighting 1 | Light control switch tail position signal / ON or OFF | ON: Light control switch in tail or head position OFF: Light control switch in neither tail nor head position |
- |
| Lighting 2 | Light control switch head position signal / ON or OFF | ON: Light control switch in head position OFF: Light control switch not in head position |
- |
| Lighting Hi | Light control switch head (Hi) position signal / ON or OFF | ON: Headlight high beam on OFF: Headlight high beam off |
- |
| Rear Fog Light SW*3 | Rear fog light switch signal / ON or OFF | ON: Rear fog light switch on OFF: Rear fog light switch off |
- |
| Front Fog Light SW*4 | Front fog light switch signal / ON or OFF | ON: Front fog light switch on OFF: Front fog light switch off |
- |
| Rear Fog Lamp Output*3 | Rear fog light output / ON or OFF | ON: Rear fog light on OFF: Rear fog light off |
- |
| Rear Fog Lamp Monitor*3 | Rear fog light output / ON or OFF | ON: Rear fog light on OFF: Rear fog light off |
- |
| Front Fog Light Output*4 | Front fog light output / ON or OFF | ON: Front fog light on OFF: Front fog light off |
- |
| Auto Light SW*1 | Light control switch AUTO position signal / ON or OFF | ON: Light control switch in AUTO position OFF: Light control switch not in AUTO position |
- |
| Head Light SW (Head) | Light control switch head position signal / ON or OFF | ON: Light control switch in head position OFF: Light control switch not in head position |
- |
| Head Light SW (Tail) | Light control switch tail position signal / ON or OFF | ON: Light control switch in tail or head position OFF: Light control switch in neither tail nor head position |
- |
| D Door Courtesy SW | Driver side door courtesy light switch signal / ON or OFF | ON: Driver side door open OFF: Driver side door closed |
- |
| Response Time*1 | Delay timing of lighting the taillights when the automatic light control sensor detects brightness change / Normal or Long | Customize setting displayed | - |
| Illumination Rate Info*1 | Illumination rate information / 0.00 ms. to 2162.65 ms. | Value is output according to ambient light levels | - |
| Sensitivity*1 | Sensitivity of the automatic light control system / Light2, Light1, Normal, Dark1 or Dark2 | Customize setting displayed | - |
| DRL Function*5 | DRL function / ON or OFF | Customize setting displayed | - |
| DRL Cancel SW*5 | DRL cancel switch / ON or OFF | ON: DRL cancel OFF: Normal |
- |
| DRL Output*5 | DRL output / ON or OFF | ON: DRL output OFF: Normal |
- |
| Light Auto OFF Delay*2 | Light auto OFF delay / Off, 30 s, 60 s or 90 s | Customize setting displayed | - |
| Follow Me Home Lighting Time*2 | Changes the lighting time of the follow me home system / 30 s,60 s, 90s, or 120s | Customize setting displayed | - |
Tech Tips
Items for which there are no settings do not appear on the GTS, or do not operate.
*1: w/ Automatic Light Control System
*2: w/ Follow Me Home System
*3: w/ Rear Fog Light
*4: w/ Front Fog Light
*5: w/ Daytime Running Light System
ACTIVE TEST
Tech Tips
Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Daytime Running Light*1 | Daytime running lights | ON/OFF | - |
| Taillight Relay | Taillight relay | ON/OFF | - |
| Headlight Relay | Headlight relay | ON/OFF | - |
| Headlight Hi | Headlight (high beam headlights) | ON/OFF | - |
| Front Fog Light Relay*2 | Front fog light relay | ON/OFF | - |
| Rear Fog Light Relay*3 | Rear fog light relay | ON/OFF | - |
Tech Tips
Items for which there are no settings do not appear on the GTS, or do not operate.
*1: w/ Daytime Running Light System
*2: w/ Front Fog Light
*3: w/ Rear Fog Light