CLEARANCE WARNING ECU INSTALLATION

PROCEDURE

1. INSTALL CLEARANCE WARNING ECU ASSEMBLY

   Tip:

   A bolt without a torque specification is shown in the standardbolt chart.

   Click here

   1. Install the clearance warning ECU assembly with the 2 nuts.

   2. Connect the connector.

2. INSTALL INSTRUMENT PANEL BOX ASSEMBLY

   Click here

3. INSTALL INSTRUMENT PANEL BOX DOOR COVER

   Click here

4. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

   Click here

5. INSTALL LOWER INSTRUMENT COVER LH

   Click here

6. INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY

   Click here

7. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH

   Click here

8. INSTALL INSTRUMENT SIDE PANEL RH

   Click here

9. INSTALL INSTRUMENT PANEL FINISH PANEL END RH

   Click here

10. INSTALL FRONT NO. 2 CONSOLE BOX INSERT

    Click here

11. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

12. INSTALL COWL SIDE TRIM BOARD RH

    1. Attach the clip and claw to install the cowl side trim board.

    2. Install the clip.

13. INSTALL DOOR SCUFF PLATE ASSEMBLY RH

    1. w/ Illumination:

       Connect the connector.

    2. Attach the 4 clips, 10 claws and 2 guides to install the door scuff plate.

14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereClick hereClick here).

15. CHECK SRS WARNING LIGHT

    1. Check the SRS warning light (Click here).