MILLIMETER WAVE RADAR SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Note

If the millimeter wave radar sensor assembly has been struck or dropped, replace the millimeter wave radar sensor assembly with a new one.

PROCEDURE


  1. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY

    Note

    When the front bumper assembly, radiator grille, millimeter wave radar sensor assembly or No. 1 millimeter wave radar sensor bracket is replaced, check that the position of the manual axis switching mechanism is standard.


    1. B006DBPC01
      *a Manual axis switching mechanism
      *b Bolt

      Set beam axis to the standard position.


      1. Turn the bolt so that the beam axis change mechanism is positioned as shown in the illustration.

        Specified Condition
        A
        3.0 to 5.0 mm (0.12 to 0.20 in.)
    2. B006A4EC01
      *a Guide
      B006AHR Screw
      B006EC9 Bolt

      Attach the guide.

    3. Temporarily install the millimeter wave radar sensor assembly with the 2 bolts and 2 screws.

    4. Tighten the 2 bolts and 2 screws in the order shown in the illustration.

      Torque:
      Bolt
      2.5 N*m  { 25 kgf*cm, 22 in.*lbf }

  2. INSTALL FRONT BUMPER ASSEMBLY


    1. for except Sport Package:

      Click here

    2. for Sport Package:

      Click here

  3. ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY


    1. When the millimeter wave radar sensor assembly is replaced, or the No. 1 millimeter wave radar sensor bracket is removed/installed, adjust the millimeter wave radar sensor assembly.

      Click here