AMPLIFIER ANTENNA INSTALLATION

PROCEDURE

  1. INSTALL ANTENNA COVER KIT

    1. When reusing the No. 1 amplifier antenna assembly:

      Note:

      New seals have specific front and rear ends. Make sure to install the seal in the correct direction, as incorrect installation may cause water leakage, etc.

      1. E332883

        Before removing the peeling paper from the seal, place the seal on the antenna as shown in the illustration and check the front and rear ends.

      2. E319016

        Remove the peeling paper, align the mark on the seal with the mark on the front of the antenna and install the seal to the antenna.

    2. E332829N01

      Attach the claws and guides to install the No. 1 amplifier antenna assembly as indicated by the arrows in the order shown in the illustration.

  2. INSTALL NO. 1 AMPLIFIER ANTENNA ASSEMBLY

    1. E332830

      Temporarily install the No. 1 amplifier antenna assembly to the vehicle.

    2. E332825

      Insert the a new washer and holder to install the No. 1 amplifier antenna with the bolt.

      9.5 N*m

      97 kgf*cm

      84 in.*lbf

    3. E332824

      Connect the connector.

  3. INSTALL ROOF HEADLINING ASSEMBLY

    Click here

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereClick here).