THROTTLE BODY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during throttle body with motor assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

  • Throttle body with motor assembly

  • Cleaning the deposits from the throttle body with motor assembly

 Inspection after repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here

PROCEDURE


  1. REMOVE V-BANK COVER SUB-ASSEMBLY

    Click here

  2. REMOVE RADIATOR COVER PLATE

    Click here

  3. REMOVE UPPER RADIATOR SUPPORT SEAL

    Click here

  4. REMOVE LOWER RADIATOR AIR DEFLECTOR

    Click here

  5. REMOVE RADIATOR SUPPORT TO CROSS MEMBER BRACE SUB-ASSEMBLY RH

    Click here

  6. DRAIN ENGINE COOLANT

    Click here

  7. DISCONNECT NO. 2 PCV HOSE


    1. B005X1Q

      Slide the clip and disconnect the No. 2 PCV hose from the cylinder head cover sub-assembly.

  8. REMOVE NO. 1 AIR CLEANER INLET


    1. B005RSIC01
      B006AHR Pull Out

      Pull out the pin of the No. 1 air cleaner inlet and remove it from the air cleaner with air cleaner hose.

      Note

      When removing the No. 1 air cleaner inlet, be careful not to lose the air cleaner support on the underside of the No. 1 air cleaner inlet.

  9. REMOVE AIR CLEANER WITH AIR CLEANER HOSE


    1. B005URA

      Disconnect the mass air flow meter sub-assembly connector.

    2. Detach the wire harness clamp.

    3. B005V3K

      Detach the clamp from the air cleaner with air cleaner hose.

    4. B005VXA

      Pull out the 3 air cleaner with air cleaner hose pins from the air cleaner support.

      Note

      When removing the air cleaner with air cleaner hose, be careful not to lose the air cleaner support on the underside of the air cleaner assembly.

    5. Loosen the hose clamp and remove the air cleaner with air cleaner hose from the throttle body with motor assembly.

  10. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY


    1. B005VEE

      Disconnect the throttle body with motor assembly connector.

    2. Remove the 4 bolts and throttle body with motor assembly from the intake air surge tank assembly.

      Note

      If the throttle body with motor assembly has been struck or dropped, replace it.

    3. B005SPU

      Slide the 2 clips, disconnect the water by-pass hose and No. 2 water by-pass hose from the throttle body with motor assembly.

    4. Remove the gasket from the intake air surge tank assembly.