AIR SWITCHING VALVE(for Bank 2) INSTALLATION

PROCEDURE

1. INSTALL AIR SWITCHING VALVE ASSEMBLY

   1. 

      *1	No. 3 Air Tube
      *2	Air Switching Valve
      *3	Claw

      Install a new gasket and the air switching valve with the 3 bolts.

      24 N*m

      245 kgf*cm

      18 ft.*lbf

      Note:

      Make sure the claws of the gasket are not caught between the air switching valve and No. 3 air tube.

   2. Install the 2 bolts.

      10 N*m

      102 kgf*cm

      7 ft.*lbf

   3. Connect the wire harness clamp bracket with the bolt.

      8.0 N*m

      82 kgf*cm

      71 in.*lbf

   4. Attach the wire harness clamp and connect the air switching valve connector.

2. CONNECT NO. 1 AIR INJECTION SYSTEM HOSE

   1. 

      *1	Projection
      *2	Paint Mark

      Align the paint mark with the projection and connect the No. 1 air injection system hose.

      Tip:

      Make sure the direction of the hose clamp is as shown in the illustration.

3. CONNECT NO. 3 VENTILATION HOSE

   1. 

      *1	Paint Mark
      *a	Front

      Connect the No. 3 ventilation hose.

      Tip:

      The direction of the hose clamp is indicated in the illustration.

4. INSTALL AIR CLEANER CAP AND HOSE

   Click hereClick hereClick here

5. INSTALL V-BANK COVER SUB-ASSEMBLY

   Click hereClick hereClick here

6. INSTALL ENGINE ROOM SIDE COVER

   Click hereClick hereClick here