HEATED OXYGEN SENSOR(for Sensor 2) INSTALLATION

PROCEDURE

INSTALL HEATED OXYGEN SENSOR (Sensor 2)

*a	Length of SST 30 mm (1.18 in.)
*b	Length of Torque Wrench 260 mm (10.2 in.)

Using SST, install the heated oxygen sensor (sensor 2) to the front exhaust pipe assembly.

09224-00010

without SST [Torque (N*m (kgf*cm, ft.*lbf))]

44 N*m

449 kgf*cm

32 ft.*lbf

with SST [Reading of Torque wrench (N*m (kgf*cm, ft.*lbf))]

39 N*m

398 kgf*cm

29 ft.*lbf

Note:

If the heated oxygen sensor (sensor 2) has been struck or dropped, replace it.

Tip:

This torque value is effective when SST is parallel to the torque wrench.
The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 260 mm (10.2 in.).
If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values.
Click here