STARTER INSTALLATION

PROCEDURE

1. INSTALL FLYWHEEL HOUSING SIDE COVER

   1. Install the flywheel housing side cover to the cylinder block.

2. INSTALL STARTER ASSEMBLY

   1. Install the starter with the 2 bolts.

      37 N*m

      380 kgf*cm

      27 ft.*lbf

   2. Connect the connector.

   3. Connect the starter wire with the nut.

      9.8 N*m

      100 kgf*cm

      87 in.*lbf

   4. Close the terminal cap.

3. INSTALL BATTERY CARRIER

   Click here

4. INSTALL BATTERY TRAY

5. INSTALL BATTERY

6. INSTALL BATTERY CLAMP SUB-ASSEMBLY

   Click here

7. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

   Click here

8. INSTALL NO. 1 ENGINE UNDER COVER

   Click here

9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

10. INSTALL RADIATOR SUPPORT OPENING COVER

    Click here

11. INSTALL NO. 2 CYLINDER HEAD COVER

    Click here