STEERING ANGLE SENSOR REMOVAL

PROCEDURE

1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   Note:

   • After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

   • When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

3. REMOVE STEERING WHEEL ASSEMBLY

   1. Remove the steering wheel assembly (Click hereClick here).

4. REMOVE STEERING COLUMN LOWER COVER

   Click hereClick here

5. REMOVE STEERING COLUMN UPPER COVER

   Click hereClick here

6. REMOVE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY

   1. Remove the spiral with sensor cable sub-assembly (Click here).

      Note:

      • Do not replace the spiral cable with the battery connected and the engine switch on.

      • Do not rotate the spiral cable with the battery connected and the engine switch on.

      • Make sure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.

      • Do not remove the steering angle sensor from the spiral cable.