DRIVING SUPPORT ECU REMOVAL

PROCEDURE

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note:

    • After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  2. REMOVE DOOR SCUFF PLATE ASSEMBLY RH

    Click here

  3. REMOVE COWL SIDE TRIM BOARD RH

    Click here

  4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH

    Click here

  5. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  6. REMOVE LOWER INSTRUMENT COVER LH

    Click hereClick here

  7. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click hereClick here

  8. REMOVE INSTRUMENT SIDE PANEL RH

    Click hereClick here

  9. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH

    Click hereClick here

  10. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY

    Click hereClick here

  11. REMOVE INSTRUMENT PANEL BOX DOOR COVER

    Click hereClick here

  12. REMOVE INSTRUMENT PANEL BOX ASSEMBLY

    Click hereClick here

  13. REMOVE TELEMATICS TRANSCEIVER

    Click hereClick here

  14. REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY

    Click hereClick here

  15. REMOVE ECU INTEGRATION BOX RH

    Click hereClick here

  16. REMOVE DRIVING SUPPORT ECU ASSEMBLY

    E198279

    1. Detach the claw and remove the driving support ECU assembly.