FRONT SEAT SIDE AIRBAG ASSEMBLY(for Manual Seat) REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

  • Wear protective gloves. Sharp areas on the seat frame and adjuster may injure your hands.

  • If the side airbag was deployed, replace the front seat airbag assembly, front seatback frame sub-assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.

Tip:

  • Use the same procedure for the driver side of RHD and LHD vehicles.

  • The procedures listed below are for the driver side of LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE

  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    Click here

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click hereClick hereClick hereClick hereClick here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick hereClick hereClick hereClick here

  3. REMOVE FRONT SEAT ASSEMBLY LH

    Click here

  4. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH

    Click hereClick hereClick here

  5. REMOVE VERTICAL ADJUSTING HANDLE LH

    Click hereClick hereClick here

  6. REMOVE FRONT SEAT CUSHION SHIELD LH

    Click hereClick hereClick here

  7. REMOVE FRONT INNER SEAT CUSHION SHIELD LH

    Click hereClick hereClick here

  8. REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY

    Click hereClick hereClick here

  9. REMOVE FRONT SEAT HEADREST SUPPORT

    Click hereClick hereClick here

  10. REMOVE SEPARATE TYPE FRONT SEATBACK COVER

    Click hereClick hereClick here

  11. REMOVE SEPARATE TYPE FRONT SEATBACK PAD

    Click hereClick hereClick here

  12. REMOVE FRONT SEAT AIRBAG ASSEMBLY LH

    1. B339284

      for Single Type:

      1. Detach the 2 clamps from the front seatback frame sub-assembly.

      2. Remove the 2 nuts and front seat airbag assembly LH.

        CAUTION:

        • The nuts must not be reused.

        • Make sure that the front seatback frame sub-assembly is not deformed. If it is, replace it with a new one.

    2. B339285

      for Dual Type:

      1. Detach the 2 clamps from the front seatback frame sub-assembly.

      2. Remove the 2 nuts and front seat airbag assembly LH.

        CAUTION:

        • The nuts must not be reused.

        • Make sure that the front seatback frame sub-assembly is not deformed. If it is, replace it with a new one.