POWER WINDOW REGULATOR MOTOR(for Rear Door) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

  2. REMOVE DECK BOARD ASSEMBLY

    Click here

  3. REMOVE NO. 1 DECK BOARD

    Click here

  4. REMOVE NO. 2 DECK BOARD

    Click here

  5. REMOVE REAR DECK FLOOR BOX

    Click here

  6. REMOVE DECK FLOOR BOX RH

    Click here

  7. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  9. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

    Click here

  10. REMOVE REAR DOOR ARMREST COVER

    Click here

  11. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  12. REMOVE REAR NO. 2 SPEAKER ASSEMBLY (for 8 Speakers)

    Click here

  13. REMOVE REAR DOOR TRIM BRACKET

    Click here

  14. REMOVE REAR DOOR SERVICE HOLE COVER

    Click here

  15. REMOVE REAR DOOR GLASS RUN

    Click here

  16. DISCONNECT REAR DOOR WEATHERSTRIP


    1. Disconnect the upper part of rear door weatherstrip.

  17. REMOVE REAR DOOR WINDOW GUIDE SUB-ASSEMBLY

    Click here

  18. REMOVE REAR DOOR REAR GUIDE SEAL

    Click here

  19. REMOVE REAR DOOR GLASS SUB-ASSEMBLY

    Click here

  20. REMOVE REAR DOOR POWER WINDOW REGULATOR ASSEMBLY

    Click here

  21. REMOVE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY


    1. A005EUU

      Using a T25 "TORX" socket wrench, remove the 3 screws and the rear power window regulator motor assembly.