REAR AIRBAG SENSOR REMOVAL

CAUTION / NOTICE / HINT

Tip:
  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note:
    • After turning the engine switch off, waiting timemay be required before disconnecting the cablefrom the battery terminal. Therefore, make sure toread the disconnecting the cable from the batteryterminal notice before proceeding with work (Click hereClick hereClick here).

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereClick hereClick hereClick here).

  2. REMOVE REAR NO. 2 SEAT ASSEMBLY (w/ Rear No. 2 Seat)

    1. Remove the rear No. 2 seat assembly (Click here).

  3. REMOVE REAR NO. 1 FLOOR STEP COVER (w/ Rear No. 2 Seat)

  4. REMOVE QUARTER SCUFF PLATE LH (w/ Rear No. 2 Seat)

  5. REMOVE REAR DOOR SCUFF PLATE LH

  6. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

  7. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

  8. REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER (w/o Rear No. 2 Seat)

  9. REMOVE NO. 1 DECK BOARD SUB-ASSEMBLY (w/o Rear No. 2 Seat)

  10. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE (w/o Rear No. 2 Seat)

  11. REMOVE REAR FLOOR CARPET ASSEMBLY (w/o Rear No. 2 Seat)

  12. REMOVE REAR NO. 1 SEAT OUTER LAP BELT ANCHOR COVER

  13. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

  14. REMOVE NO. 1 TONNEAU COVER HOLDER CAP

  15. REMOVE ASSIST GRIP PLUG (w/ Rear No. 2 Seat)

  16. REMOVE ASSIST GRIP SUB-ASSEMBLY (w/ Rear No. 2 Seat)

  17. REMOVE REAR SEATBACK LOCK CONTROL LEVER BASE LH (w/ Rear No. 2 Seat)

  18. REMOVE FRONT DECK SIDE TRIM COVER

  19. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

  20. REMOVE REAR AIRBAG SENSOR LH

    1. B238363

      Remove the nut and rear airbag sensor.

    2. Disconnect the connector.