REAR VIEW MONITOR SYSTEM
| DTC Code | DTC Name |
|---|---|
| HOW TO PROCEED WITH TROUBLESHOOTING |
CAUTION / NOTICE / HINT
Use the following procedure to troubleshoot the rear view monitor system.
PROCEDURE
VEHICLE BROUGHT TO WORKSHOP
Result
Proceed to
NEXT
INSPECT BATTERY VOLTAGE
Measure the battery voltage with the ignition switch off.
Standard voltage
11 to 14 V
Tip:If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
Result
Proceed to
NEXT
PROBLEM SYMPTOM CONFIRMATION
Result
Proceed to
Symptom does not occur
Symptom occurs
Symptom occurs CHECK IF SAME SYMPTOM APPEARS IN OTHER SYSTEMClick here
SYMPTOM SIMULATION
Result
Proceed to
NEXT
CHECK IF SAME SYMPTOM APPEARS IN OTHER SYSTEM
w/o Navigation System
Refer to the audio and visual system (for Radio and Display Type).
w/ Navigation System
Refer to the navigation system.
Result
Proceed to
Symptom does not appear
Symptom appears (w/o Navigation System)
Symptom appears (w/ Navigation System)
PROBLEM SYMPTOMS TABLE
Refer to Problem Symptoms Table.
Result
Proceed to
Fault is not listed in Problem Symptoms Table
Fault is listed in Problem Symptoms Table
Fault is listed in Problem Symptoms Table ADJUST, REPAIR OR REPLACEClick here
PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM
Terminals of ECU.
Result
Proceed to
NEXT
ADJUST, REPAIR OR REPLACE
Result
Proceed to
NEXT
CONFIRMATION TEST
Result
Proceed to
NEXT
NEXT END