FRONT SEAT OUTER BELT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front seat outer belt assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control)

Click here

Pre-collision system
Memorize steering angle neutral point Parking assist monitor system

Click here

CAUTION:


  • Wear protective gloves. Sharp areas on the parts may injure your hands.

  • B0084SX

    Be sure to read Precaution thoroughly before servicing.

    Click here

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    for 2AR-FE:

    Click here

    for A25A-FKS:

    Click here

    for 2GR-FKS:

    Click here

    CAUTION:


    • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    • If an airbag deploys for any reason, it may cause a serious injury.

    B0087PP

  3. REMOVE FRONT DOOR SCUFF PLATE

    Click here

  4. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP


    1. Disconnect the front door opening trim weatherstrip.

  5. REMOVE REAR DOOR SCUFF PLATE

    Click here

  6. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP


    1. Disconnect the rear door opening trim weatherstrip.

  7. REMOVE LAP BELT OUTER ANCHOR COVER


    1. B0084LE

      Disengage the 3 claws to remove the lap belt outer anchor cover.

  8. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY


    1. B0086PP

      Remove the bolt to disconnect the floor anchor of the front seat outer belt assembly.

  9. REMOVE LOWER CENTER PILLAR GARNISH

    Click here

  10. REMOVE UPPER CENTER PILLAR GARNISH

    Click here

  11. REMOVE FRONT SEAT OUTER BELT ASSEMBLY


    1. B00868P

      Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.

    2. B0083FHC01
      *a Protective Tape
      *b Locking Button
      *c Release

      Using a screwdriver, pull out the locking button as shown in the illustration to release the lock and disconnect the pretensioner connector.

      Tech Tips

      Tape the screwdriver tip before use.

    3. B0085GN

      Remove the 2 bolts.

    4. Disengage the 2 guides to remove the front seat outer belt assembly.

  12. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


    1. B0084BI

      Remove the 2 bolts.

    2. Disengage the guide to remove the front shoulder belt anchor adjuster assembly.