HEATED OXYGEN SENSOR INSTALLATION

PROCEDURE


  1. INSTALL HEATED OXYGEN SENSOR


    1. B008H7PC01
      *a Torque Wrench Fulcrum Length

      Using SST, install the heated oxygen sensor to the center exhaust pipe assembly.

      SST
      09224-00011
      Torque
      Specified tightening torque
      44 N*m (449 kgf*cm, 32 ft.*lbf)

      Note

      Do not damage the heated oxygen sensor.

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 37.7 N*m (384 kgf*cm, 28 ft.*lbf)

    2. Attach the wire harness clamp.

    3. Pass the heated oxygen sensor connector through the floor panel and install the grommet.

    4. Connect the heated oxygen sensor connector.

  2. INSTALL FRONT FLOOR COVER CENTER LH

    Click here

  3. INSTALL CONSOLE BOX ASSEMBLY

    Click here

  4. INSPECT FOR EXHAUST GAS LEAK

    Click here