REAR BRAKE (for 2WD) DISASSEMBLY

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.


  1. DISCONNECT REAR BRAKE SHOE RETURN SPRING


    1. A01E11SE01

      Using SST, disconnect the spring from the front brake shoe and rear brake shoe.

      SST
      09703-30011

      Note

      Be careful not to damage the wheel cylinder boot.

  2. REMOVE FRONT BRAKE SHOE


    1. A01DWL7E01

      Using SST, remove the shoe hold down spring cup, shoe hold down spring and pin.

      SST
      09718-00010

    2. Remove the shoe and tension spring.

  3. REMOVE PARKING BRAKE SHOE STRUT SET LH


    1. Remove the strut set from the rear brake shoe.

  4. REMOVE REAR BRAKE SHOE


    1. A01DW36E01

      Using SST, remove the shoe hold down spring cup, shoe hold down spring and pin.

      SST
      09718-00010

    2. Using needle-nose pliers, remove the adjust lever tension spring from the automatic adjust lever. Then remove the shoe.

    3. A01DVK9

      Using needle-nose pliers, disconnect the No. 3 parking brake cable from the parking brake shoe lever.

  5. REMOVE REAR BRAKE AUTOMATIC ADJUST LEVER LH


    1. A01E0BM

      Using a screwdriver, remove the E-ring and lever.

  6. REMOVE REAR BRAKE PARKING BRAKE SHOE LEVER SUB-ASSEMBLY


    1. A01DYJR

      Using a screwdriver, remove the C-washer and lever.

  7. REMOVE REAR WHEEL BRAKE CYLINDER ASSEMBLY LH


    1. A01E2IN

      Using a union nut wrench, disconnect the brake line.

    2. Remove the 2 bolts and cylinder.

  8. REMOVE REAR WHEEL BRAKE CYLINDER CUP


    1. Remove the 2 cylinder dust boots from the cylinder.

    2. Remove the 2 pistons and compression spring.

    3. Remove the 2 cups from each piston.

  9. REMOVE REAR BRAKE DRUM BLEEDER PLUG


    1. Remove the bleeder plug cap and bleeder plug from the cylinder.