PANORAMIC VIEW MONITOR SYSTEM, Diagnostic DTC:C1694

DTC Code DTC Name
C1694 Steering Angle Initialization Incomplete

DESCRIPTION

This DTC is stored when the parking assist ECU judges that the maximum steering angle has not been memorized (steering angle setting is incomplete).

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1694

Steering Angle Initialization Incomplete

Maximum steering angle has not been memorized

  • Steering angle setting

  • Parking assist ECU

CAUTION / NOTICE / HINT

Note:

  • When "!" mark is displayed on the multi-display after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point.

    Click here

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.

    Click here

PROCEDURE

  1. PERFORM SETTINGS (STEERING ANGLE SETTING)

    1. Perform the following procedure depending on the memory conditions to register the vehicle information to the parking assist ECU.

      1. Refer to steering angle setting.

        Click here

    Result

    Proceed to

    NEXT
    NEXT

  2. CHECK FOR DTC

    1. Clear the DTCs.

      Click here

      Chassis > Panoramic View Monitor > Clear DTCs

    2. Check for DTCs.

      Click here

      Chassis > Panoramic View Monitor > Trouble Codes

      OK

      DTC C1694 is not output.

      Tip:

      • If DTC C1694 is output, perform the steering angle setting again.

      • If DTC C1694 is still output after performing the steering angle setting 3 times, replace the parking assist ECU.

    Result

    Proceed to

    OK

    NG
    OK

    END (SETTINGS ARE DEFECTIVE)

    NG

    REPLACE PARKING ASSIST ECU

    Click here