REAR AIRBAG SENSOR REMOVAL

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note:

    • w/ Navigation System:

      After the engine switch is turned off, the display and navigation module display (navigation system) records various types of memory and settings. As a result, after turning the engine switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

      Table 1. Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal

      Condition

      Waiting Time

      Vehicle enrolled in safety connect system

      6 minutes

      Vehicle not enrolled in safety connect system

      1 minute

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  2. REMOVE REAR NO. 2 SEAT ASSEMBLY (w/ Rear No. 2 Seat)

    1. Remove the rear No. 2 seat assembly (Click here).

  3. REMOVE REAR NO. 1 FLOOR STEP COVER (w/ Rear No. 2 Seat)

    Click here

  4. REMOVE QUARTER SCUFF PLATE LH (w/ Rear No. 2 Seat)

    Click here

  5. REMOVE REAR DOOR SCUFF PLATE LH

    Click here

  6. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

    Click here

  7. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

    Click here

  8. REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER (w/o Rear No. 2 Seat)

    Click here

  9. REMOVE NO. 1 DECK BOARD SUB-ASSEMBLY (w/o Rear No. 2 Seat)

    Click here

  10. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE (w/o Rear No. 2 Seat)

    Click here

  11. REMOVE REAR FLOOR CARPET ASSEMBLY (w/o Rear No. 2 Seat)

    Click here

  12. REMOVE REAR NO. 1 SEAT OUTER LAP BELT ANCHOR COVER

    Click here

  13. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

    Click here

  14. REMOVE NO. 1 TONNEAU COVER HOLDER CAP

    Click here

  15. REMOVE ASSIST GRIP PLUG (w/ Rear No. 2 Seat)

    Click here

  16. REMOVE ASSIST GRIP SUB-ASSEMBLY (w/ Rear No. 2 Seat)

    Click here

  17. REMOVE REAR SEATBACK LOCK CONTROL LEVER BASE LH (w/ Rear No. 2 Seat)

    Click here

  18. REMOVE FRONT DECK SIDE TRIM COVER

    Click here

  19. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

    Click here

  20. REMOVE REAR AIRBAG SENSOR LH

    1. B238363

      Remove the nut and rear airbag sensor.

    2. Disconnect the connector.