FRONT SEAT OUTER BELT ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tip:

Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart (Click here).

PROCEDURE

INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
1. Align the claw with the adjuster positioning hole and install the anchor adjuster with the 2 bolts.
  
  42 N*m
  
  428 kgf*cm
  
  31 ft.*lbf
  
  Tip:
  First install the lower bolt, and then install the upper bolt.

INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH

Note:

When installing the retractor, make sure the claws of the vehicle (labeled "a" in the illustration) only contact the installation areas of the retractor.

Align the seat outer belt positioning holes with the claws and install the retractor of the seat outer belt with the 2 bolts.

for bolt A

12.5 N*m

127 kgf*cm

9 ft.*lbf

for bolt B

42 N*m

428 kgf*cm

31 ft.*lbf

Tip:

First install bolt A, and then install bolt B.

Table 1. Text in Illustration
*1	Bolt A
*2	Bolt B

Connect the pretensioner connector as shown in the illustration.
Install the shoulder anchor to the shoulder belt anchor adjuster with the nut.

42 N*m

428 kgf*cm

31 ft.*lbf

INSTALL CENTER PILLAR GARNISH LH

Click here
INSTALL LAP BELT OUTER ANCHOR COVER

Click here
INSTALL NO. 2 FLOOR BOARD

Click here
INSTALL LOWER CENTER PILLAR GARNISH LH

Click here
INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH

Click here
INSTALL REAR DOOR SCUFF PLATE LH

Click here
INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH

Click here
INSTALL COWL SIDE TRIM BOARD LH

Click here
INSTALL FRONT DOOR SCUFF PLATE LH

Click here
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Note:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).