PARK / NEUTRAL POSITION SWITCH ADJUSTMENT

PROCEDURE

1. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY

   1. Remove the transmission control shaft lever.

      Click here

   2. 

      Loosen the 2 bolts of the park/neutral position switch assembly.

   3. 

      *a	Protrusion

      Align the protrusions of the park/neutral position switch assembly.

   4. 

      Hold the park/neutral position switch assembly in position and tighten the 2 bolts.

      5.4 N*m

      55 kgf*cm

      48 in.*lbf

      Note:

      After installing the park/neutral position switch assembly, confirm that the 2 protrusions on the switch are aligned.

   5. Install the transmission control shaft lever.

      Click here

   6. After the adjustment, perform the switch operation check.

      Click here