FUEL PUMP ECU(for Wagon) REMOVAL

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click hereClick here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick hereClick here

  3. REMOVE DECK BOARD SUB-ASSEMBLY (w/ Deck Board)

    Click here

  4. REMOVE DECK BOARD ASSEMBLY (w/ Deck Board)

    Click here

  5. REMOVE FRONT DECK FLOOR BOX (w/ Deck Board)

    Click here

  6. REMOVE REAR FLOOR MAT ASSEMBLY

    Click here

  7. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY (w/ Deck Board)

    Click here

  8. REMOVE DECK FLOOR BOX LH (w/o Woofer)

    Click here

  9. REMOVE TONNEAU COVER ASSEMBLY

    Click here

  10. REMOVE ROOM PARTITION NET ASSEMBLY (w/ Partition Net)

    Click here

  11. REMOVE REAR DECK TRIM COVER

    Click here

  12. REMOVE REAR SEAT CUSHION ASSEMBLY

    Click here

  13. REMOVE REAR SEAT HEADREST ASSEMBLY

  14. DISCONNECT REAR NO. 1 SEAT LOCK CABLE ASSEMBLY

    Click here

  15. REMOVE REAR SEATBACK ASSEMBLY LH

    Click here

  16. REMOVE REAR DOOR SCUFF PLATE LH

    Click here

  17. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

    Click here

  18. REMOVE REAR SEATBACK HINGE SUB-ASSEMBLY LH

    Click here

  19. REMOVE REAR SEAT SIDE GARNISH LH

    Click here

  20. REMOVE NO. 2 DECK SIDE TRIM HOOK

    Click here

  21. REMOVE RECLINING REMOTE CONTROL BEZEL LH

    Click here

  22. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

    Click here

  23. REMOVE FUEL PUMP CONTROL ECU ASSEMBLY

    1. A306871

      Disconnect the fuel pump control ECU assembly connector.

    2. Remove the 2 bolts and fuel pump control ECU assembly.

      Note:

      Do not reuse the fuel pump control ECU assembly if it has been dropped or subjected to a severe impact.

      Tip:

      If a malfunction such as pump lock occurs and the fuel pump is damaged, excessive current may be continuously applied to the fuel pump control ECU assembly, damaging its internal parts. Make sure to replace the fuel pump control ECU assembly at the same time when replacing the fuel pump.