TOYOTA PARKING ASSIST-SENSOR SYSTEM(except Sedan), Diagnostic DTC:C1AE2

DTC Code DTC Name
C1AE2 Front Left Center Sensor

DESCRIPTION

The No. 1 ultrasonic sensor (front center LH) is installed on the front bumper. The ECU detects obstacles based on signals received from the No. 1 ultrasonic sensor (front center LH). If the No. 1 ultrasonic sensor (front center LH) has an open circuit or other malfunction, it will not function normally.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1AE2

Front Left Center Sensor

  • A malfunction of the No. 1 ultrasonic sensor (front center LH).

  • A short or open in the harness or connector

  • No. 1 ultrasonic sensor (front center LH)

  • Harness or connector

  • Clearance warning ECU assembly

WIRING DIAGRAM

E267085E53

CAUTION / NOTICE / HINT

Note:

  • If DTCs are output after repairs, turn the ignition switch to ON and turn the TOYOTA parking assist-sensor system on. Then clear the DTCs.

    Click here

  • Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization may be needed. Refer to Initialization.

    Click here

PROCEDURE

  1. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - NO. 1 ULTRASONIC SENSOR (FRONT CENTER LH))

    1. Disconnect the E98 clearance warning ECU assembly connector.

    2. Disconnect the r10 No. 1 ultrasonic sensor (front center LH) connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      E98-27 (E5) - r10-1 (EI)

      Always

      Below 1 Ω

      E98-23 (BOF) - r10-3 (BI)

      Always

      Below 1 Ω

      E98-25 (S8) - r10-2 (SI)

      Always

      Below 1 Ω

      E98-27 (E5) - E98-25 (S8)

      Always

      10 kΩ or higher

      E98-23 (BOF) - E98-25 (S8)

      Always

      10 kΩ or higher

    Result

    Proceed to

    OK

    NG
    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  2. REPLACE NO. 1 ULTRASONIC SENSOR (FRONT CENTER LH)

    1. Replace the No. 1 ultrasonic sensor (front center LH) with a known good one.

      Click here

      Tip:

      All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.

    Result

    Proceed to

    NEXT
    NEXT

  3. CHECK DTC OUTPUT

    1. Clear the DTCs.

      Body Electrical > Clearance Sonar / Simple-IPA. > Clear DTCs

    2. Check for DTCs.

      Body Electrical > Clearance Sonar / Simple-IPA. > Trouble Codes

      OK

      No DTCs are output.

    Result

    Result

    Proceed to

    OK

    A

    NG

    B
    A

    END

    B

    REPLACE CLEARANCE WARNING ECU ASSEMBLY

    for LHD:Click here

    for RHD:Click here