BLIND SPOT MONITOR SYSTEM, Diagnostic DTC:C1AC2

DTC Code DTC Name
C1AC2 Slave Module Horizontal Axis Misalignment

DESCRIPTION

This DTC is stored when the angle of the blind spot monitor sensor RH deviates more than the allowable range from the horizontal axis.

Tip:

If drum tester such as a speedometer tester, brake/speedometer combination tester or chassis dynamometer is used with the blind spot monitor system on, the blind spot monitor system may store this DTC by mistake.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1AC2

Slave Module Horizontal Axis Misalignment

When the blind spot monitor sensor deviates 5 degrees or more from the horizontal axis when the system is activated.

Blind spot monitor sensor RH

CAUTION / NOTICE / HINT

Note:

When checking for DTCs, make sure that the blind spot monitor system is on.

PROCEDURE

  1. CHECK INSTALLATION CONDITION

    1. Check the installation condition of the blind spot monitor sensor RH.

      Click here

      Tip:

      Take the appropriate action in accordance with the result.

    Result

    Proceed to

    NEXT
    NEXT

  2. PERFORM BEAM AXIS CONFIRMATION

    1. Install the rear bumper.

      Click hereClick here

    2. Perform Blind Spot Monitor Beam Axis Confirmation using the GTS.

      Click here

    Result

    Proceed to

    OK

    NG
    OK

    END

    NG

    REPLACE BLIND SPOT MONITOR SENSOR RH

    Click here