CAN COMMUNICATION SYSTEM Steering Angle Sensor Communication Stop Mode

DESCRIPTION

Detection Item Symptom Trouble Area
Steering Angle Sensor Communication Stop Mode

Either condition is met:


  • "Spiral cable (Steering Angle Sensor)" is not displayed on "Bus Check".

  • "Steering Angle Sensor Communication Stop Mode" in "DTC Combination Table" applies.

  • Power source or inside spiral cable sub-assembly (steering angle sensor)

  • Spiral cable sub-assembly (steering angle sensor) CAN branch wire or connector

  • Spiral cable sub-assembly (steering angle sensor)

WIRING DIAGRAM

B007PQZE01

INSPECTION PROCEDURE

Note

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

Tech Tips

Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.

PROCEDURE


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


    1. Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the CAN main wire and CAN branch wire.

      CAUTION:

      For vehicles with an airbag system:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.


    NEXT

  2. CHECK FOR OPEN IN CAN BUS WIRE (SPIRAL CABLE SUB-ASSEMBLY CAN BRANCH WIRE)


    1. B007SC1E01
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Spiral Cable Sub-assembly [Steering Angle Sensor])

      Disconnect the spiral cable sub-assembly (steering angle sensor) connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      H92-3 (CANH) - H92-2 (CANL) Ignition switch off 54 to 69 Ω

    NG

    REPAIR OR REPLACE SPIRAL CABLE CAN BRANCH WIRE OR CONNECTOR (CANH, CANL)

    OK

  3. CHECK HARNESS AND CONNECTOR (SPIRAL CABLE SUB-ASSEMBLY - BATTERY AND BODY GROUND)


    1. B007SC1E02
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Spiral Cable Sub-assembly [Steering Angle Sensor])

      Connect the cable to the negative (-) battery terminal.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      H92-1 (ESS) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      H92-5 (BAT) - Body ground Always 11 to 14 V
      H92-4 (IG) - Body ground Ignition switch ON 11 to 14 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    REPLACE SPIRAL CABLE SUB-ASSEMBLY (STEERING ANGLE SENSOR) Click here