SEAT BELT WARNING SYSTEM DATA LIST / ACTIVE TEST

  1. DATA LIST

    Note:

    In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    Tip:

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Combination Meter / Data List.

    5. Read the Data List according to the display on the GTS.

      Body Electrical > Combination Meter > Data List

      Tester Display

      Measurement Item

      Range

      Normal Condition

      Diagnostic Note

      P-Seatbelt Buckle SW

      Front passenger seat belt buckle switch signal

      ON or OFF

      OFF: Front passenger seat belt fastened

      ON: Front passenger seat belt unfastened

      The front passenger seat is occupied

      2nd-Row Seatbelt Buckle (R)

      Rear RH seat belt buckle switch signal

      ON or OFF

      OFF: Rear RH seat belt fastened

      ON: Rear RH seat belt not fastened

      -

      2nd-Row Seatbelt Buckle (L)

      Rear LH seat belt buckle switch signal

      ON or OFF

      OFF: Rear LH seat belt fastened

      ON: Rear LH seat belt not fastened

      -

      Driver Side Seatbelt Buckle Switch

      Driver seat belt buckle switch signal

      ON or OFF

      OFF: Driver seat belt fastened

      ON: Driver seat belt unfastened

      -

      Driver Side Door

      Front door courtesy light switch assembly (driver door) signal

      OPEN or CLOSE

      OPEN: Driver door open

      CLOSE: Driver door closed

      -

      Door All (Except for Driver Side Seat)

      Door courtesy light switch (except driver door) signal

      OPEN or CLOSE

      OPEN: Any door (except driver door) open

      CLOSE: All door (except driver door) closed

      -

      Driver Side Seatbelt Warning Buzzer

      Driver seat belt warning buzzer

      ON or OFF

      Customized setting displayed

      -

      P-Seatbelt Warning Buzzer

      Front passenger seat belt warning buzzer

      ON or OFF

      Customized setting displayed

      -

      Rear Seatbelt Warning Buzzer

      Rear seat belt warning buzzer

      ON or OFF

      Customized setting displayed

      -

  2. ACTIVE TEST

    Tip:

    Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Combination Meter / Active Test.

    5. Perform the Active Test according to the display on the GTS.

      Body Electrical > Combination Meter > Active Test

      Tester Display

      Measurement Item

      Control Range

      Diagnostic Note

      Front Passenger Side Seat Belt

      Front seat belt warning light

      OFF/ON

      -

      Driver Side Seat Belt

      Front seat belt warning light

      OFF/ON

      -