REAR ACTIVE STABILIZER CONTROL ACTUATOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear active stabilizer control actuator removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Rear active stabilizer control actuator assembly Motor rotation angle sensor calibration Active stabilizer is not operating

Click here

Note

Be sure to read the "PRECAUTION" thoroughly before servicing.

Click here

PROCEDURE


  1. REMOVE REAR SUSPENSION MEMBER SUB-ASSEMBLY

    Click here

  2. REMOVE REAR STABILIZER LINK ASSEMBLY LH

    Click here

  3. REMOVE REAR STABILIZER LINK ASSEMBLY RH

    Tech Tips

    Perform the same procedure as for the LH side.

  4. REMOVE REAR ACTIVE STABILIZER CONTROL ACTUATOR ASSEMBLY


    1. B006F18

      Disengage the 2 clamps to disconnect the wire harness.

    2. Remove the 4 bolts and rear active stabilizer control actuator assembly from the rear suspension member sub-assembly.

  5. REMOVE REAR NO. 1 STABILIZER BAR BRACKET LH


    1. Remove the rear No. 1 stabilizer bar bracket LH from the rear stabilizer bushing.

  6. REMOVE REAR NO. 1 STABILIZER BAR BRACKET RH

    Tech Tips

    Perform the same procedure as for the LH side.

  7. REMOVE REAR STABILIZER BUSHING


    1. Remove the 2 rear stabilizer bushings from the rear active stabilizer control actuator assembly.