KNOCK SENSOR INSTALLATION

PROCEDURE

  1. INSTALL KNOCK CONTROL SENSOR

    1. A321718C01

      *a

      Top

      *b

      37.5°

      *c

      22.5°

      Install the knock control sensor to the cylinder block sub-assembly with the bolt so that the knock control sensor installation position is as shown in the illustration.

      20 N*m

      204 kgf*cm

      15 ft.*lbf

      Note:

      • If the knock control sensor has been struck or dropped, replace it.

      • Make sure that the knock control sensor is in the correct position.

    2. Connect the knock control sensor connector.

  2. INSTALL INTAKE MANIFOLD

    Click here