FRONT SEAT ASSEMBLY(for Manual Seat) INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:


  • B0025TC

    Wear protective gloves. Sharp areas on the parts may injure your hands.

  • There is risk of injury.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedures listed below are for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL FRONT SEAT ASSEMBLY LH


    1. B0027S6

      Place the front seat assembly LH in the vehicle, as shown in the illustration.

      Note

      Do not damage the front seat assembly LH, body exterior or interior parts.

    2. B002823

      Attach the wire harness clamp.

    3. Connect the connector.

    4. w/ Front Seat Side Airbag:

      Connect the front seat airbag assembly LH connector.

    5. Temporarily install the front seat assembly LH with the 4 bolts.

    6. Operate the seat track handle sub-assembly LH to slide the front seat assembly LH rearmost position.

    7. B0026FBN01

      Tighten the 2 bolts on the front side of front seat assembly LH in the order shown in the illustration.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

    8. Operate the seat track handle sub-assembly LH to slide the front seat assembly LH to the frontmost position.

    9. B00267TN01

      Tighten the 2 bolts on the rear side of front seat assembly LH in the order shown in the illustration.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

  2. INSTALL FRONT SEAT REAR INNER TRACK COVER LH (w/ Cover)


    1. B00274IC02
      B0069FO Install in this Direction (1)
      B0068NX Install in this Direction (2)

      Push in installation direction (1) shown in the illustration to attach the guide.

    2. Push in installation direction (2) shown in the illustration to attach the claw and install the front seat rear inner track cover LH.

  3. INSTALL FRONT SEAT REAR OUTER TRACK COVER LH (w/ Cover)


    1. B0024SVC01
      B0069FO Install in this Direction (1)
      B0068NX Install in this Direction (2)

      Push in installation direction (1) shown in the illustration to attach the guide.

    2. Push in installation direction (2) shown in the illustration to attach the claw and install the front seat rear outer track cover LH.

    3. Operate the seat track handle sub-assembly LH to slide the front seat assembly LH to the center position.

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  5. PERFORM DIAGNOSTIC SYSTEM CHECK (w/ Front Seat Side Airbag)

    for AIRBAG SYSTEM (for Type A):

    Click here

    for AIRBAG SYSTEM (for Type B):

    Click here

    for AIRBAG SYSTEM (for Type C):

    Click here

  6. CHECK SRS WARNING LIGHT (w/ Front Seat Side Airbag)

    for AIRBAG SYSTEM (for Type A):

    Click here

    for AIRBAG SYSTEM (for Type B):

    Click here

    for AIRBAG SYSTEM (for Type C):

    Click here