KNEE AIRBAG ASSEMBLY(for Driver Side) REMOVAL

PROCEDURE

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note:

    • After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click hereClick hereClick here).

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereClick hereClick hereClick here).

  2. REMOVE DOOR SCUFF PLATE ASSEMBLY LH

    Click hereClick here

  3. REMOVE COWL SIDE TRIM BOARD LH

    Click hereClick here

  4. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click hereClick here

  5. REMOVE INSTRUMENT PANEL FINISH PANEL END LH

    Click hereClick here

  6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

    Click hereClick here

  7. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

    1. B253441

      Remove the 4 bolts and airbag assembly.

    2. Disconnect the connector.

      Note:

      When handling the airbag connector, take care not to damage the airbag wire harness.