FRONT SEAT OUTER BELT ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


    1. B0084BIE01

      Engage the guide and temporarily install the front shoulder belt anchor adjuster assembly with the 2 bolts.

    2. Fully tighten the bolt (A) and then the bolt (B) to install the front shoulder belt anchor adjuster assembly.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

  2. INSPECT FRONT SEAT OUTER BELT ASSEMBLY

    Click here

  3. INSTALL FRONT SEAT OUTER BELT ASSEMBLY


    1. B0085GNE01

      Engage the 2 guides and temporarily install the front seat outer belt assembly with the 2 bolts.

    2. Fully tighten the bolt (A) and then the bolt (B) to install the front seat outer belt assembly.

      Torque:
      Bolt (A)
      12.5 N*m  { 127 kgf*cm, 9 ft.*lbf }
      Bolt (B)
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }
    3. B0083PAC01
      *a Locking Button
      *b Lock

      Connect the pretensioner connector and lock the locking button as shown in the illustration.

      Note

      Securely lock the locking button.

    4. Connect the shoulder anchor of the front seat outer belt assembly with the nut.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

    5. Check that the ELR locks.

      Note

      This check should be performed with the front seat outer belt assembly installed to the vehicle.


      1. With the front seat outer belt assembly installed to the vehicle, check that the belt locks when it is pulled out quickly.

  4. INSTALL UPPER CENTER PILLAR GARNISH

    Click here

  5. INSTALL LOWER CENTER PILLAR GARNISH

    Click here

  6. CONNECT FRONT SEAT OUTER BELT ASSEMBLY


    1. Connect the floor anchor of the front seat outer belt assembly with the bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

  7. INSTALL LAP BELT OUTER ANCHOR COVER


    1. Engage the 3 claws to install the lap belt outer anchor cover.

  8. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP

    Click here

  9. INSTALL REAR DOOR SCUFF PLATE

    Click here

  10. CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP

    Click here

  11. INSTALL FRONT DOOR SCUFF PLATE

    Click here

  12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    for 2AR-FE:

    Click here

    for A25A-FKS:

    Click here

    for 2GR-FKS:

    Click here

    for 6AR-FSE:

    Click here

  13. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  14. INSPECT SRS WARNING LIGHT

    Click here