FRONT LOWER BALL JOINT INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL FRONT LOWER BALL JOINT ASSEMBLY LH


    1. Secure the front axle assembly between aluminum plates in a vise.

      Note

      When using a vise, do not overtighten it.

    2. Install the front lower ball joint to the front axle assembly with the nut.

      Torque:
      133 N*m  { 1356 kgf*cm, 98 ft.*lbf }

    3. Install a new clip.

      Note


      • If the holes for the clip are not aligned, align the holes by tightening the nut as necessary up to an additional 60°.

      • Make sure the claws of the clip are fully inserted into the grooves of the nut.

  2. INSTALL FRONT AXLE ASSEMBLY LH

    Click here