BACK DOOR LOCK INSPECTION

PROCEDURE

  1. INSPECT BACK DOOR LOCK ASSEMBLY

    1. E355543E01

      Check the operation of the door lock motor.

      1. Move the door lock to the closed position.

      2. Apply battery voltage to the door lock motor and check the operation of the door lock motor.

        OK

        Measurement Condition

        Specified Condition

        Battery positive (+) → 2 (ACT+)

        Battery negative (-) → 1 (ACT-)

        Open

        If the result is not specified, replace the back door lock assembly.

    2. E355543E02

      Check the operation of the door courtesy switch.

      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection

        Condition

        Specified Condition

        1 (ACT-) - 3 (D+)

        Closed

        10 kΩ or higher

        1 (ACT-) - 3 (D+)

        Open

        Below 1 Ω

        If the result is not specified, replace the back door lock assembly.