STOP AND START SYSTEM Stop and Start Cancel Switch Circuit

DTC Code DTC Name
Stop and Start Cancel Switch Circuit

DESCRIPTION

Stop and start control can be disabled by pressing the eco run cancel switch assembly. The eco run cancel switch assembly is a momentary-type switch that switches between on and off when the switch is pressed. While stop and start control is disabled, the stop and start cancel indicator light is illuminated to inform the driver.

WIRING DIAGRAM

A287084E56

PROCEDURE

  1. READ VALUE USING GTS (CANCEL SWITCH)

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Stop and Start / Data List / Cancel Switch.

    5. Read the value when the eco run cancel switch assembly is pressed.

      OK

      Tester Display

      Condition

      Normal Condition

      Cancel Switch

      Eco run cancel switch assembly is pressed

      ON

      Eco run cancel switch assembly is not pressed

      OFF

    Result

    Result

    Proceed to

    NG

    A

    OK

    B
    B

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

    Click hereClick hereClick here

    A

  2. INSPECT ECO RUN CANCEL SWITCH ASSEMBLY

    1. Inspect the eco run cancel switch assembly.

      Click here

    Result

    Proceed to

    OK

    NG
    NG

    REPLACE ECO RUN CANCEL SWITCH ASSEMBLY

    Click here

    OK

  3. CHECK HARNESS AND CONNECTOR (ECO RUN CANCEL SWITCH ASSEMBLY - BODY GROUND)

    1. Disconnect the E136 eco run cancel switch assembly connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      E136-3 (E) - Body ground

      Always

      Below 1 Ω

    Result

    Proceed to

    OK

    NG
    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  4. CHECK HARNESS AND CONNECTOR (ENGINE STOP AND START ECU - ECO RUN CANCEL SWITCH ASSEMBLY)

    1. Disconnect the E24 engine stop and start ECU connector.

    2. Disconnect the E136 eco run cancel switch assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      E24-23 (ECAN) - E136-1 (ECU)

      Always

      Below 1 Ω

      E24-23 (ECAN) - Body ground

      Always

      10 kΩ or higher

      E136-1 (ECU) - Body ground

      Always

      10 kΩ or higher

    Result

    Proceed to

    OK

    NG
    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

    Click hereClick hereClick here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR