GLOW PLUG(w/o Glow Plug Controller) INSTALLATION

PROCEDURE

  1. INSTALL GLOW PLUG ASSEMBLY

    1. Clean the glow plug assembly installation holes in the cylinder head sub-assembly.

    2. Using a 10 mm deep socket wrench, install the 4 glow plug assemblies.

      12.5 N*m

      127 kgf*cm

      9 ft.*lbf

  2. INSTALL NO. 1 GLOW PLUG CONNECTOR

    1. A236194

      Install the No. 1 glow plug connector with the 4 nuts.

      2.2 N*m

      22 kgf*cm

      19 in.*lbf

    2. Connect the wire harness with the nut.

      3.8 N*m

      39 kgf*cm

      34 in.*lbf

      Note:

      Install the glow terminal in the correct direction.

    3. Install the 5 screw grommets.

      Note:

      Push the screw grommet into the threaded portion of the glow plug by hand, and then turn it clockwise.

  3. INSTALL NO. 3 ENGINE COVER BRACKET

    1. Install the No. 3 engine cover bracket with the bolt.

      9.0 N*m

      92 kgf*cm

      80 in.*lbf

    2. Connect the wire harness clamp.

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick hereClick here

  5. INSTALL NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)

    Click hereClick hereClick here