INTAKE MANIFOLD INSTALLATION

PROCEDURE

1. INSTALL STUD BOLT (w/ Stud Bolt)

   Tip:

   If a stud bolt is deformed or the threads are damaged, replace it.

   1. 

      Using an E6 "TORX" socket wrench, install the 2 stud bolts to the intake manifold.

      5.0 N*m

      51 kgf*cm

      44 in.*lbf

2. INSTALL INTAKE MANIFOLD

   1. Install the engine cover joint to the intake manifold.

      10 N*m

      102 kgf*cm

      7 ft.*lbf

   2. Install a new No. 1 intake manifold to head gasket to the intake manifold.

   3. Temporarily install the intake manifold stay and intake manifold with the 4 bolts and 2 nuts.

   4. 

      	Bolt
      	Nut

      Tighten the 4 bolts and 2 nuts to the specified torque in several steps.

      28 N*m

      286 kgf*cm

      21 ft.*lbf

   5. Connect the No. 1 ventilation hose to the intake manifold and slide the clip to secure it.

   6. Connect the No. 1 vacuum transmitting hose to the intake manifold and slide the clip to secure it.

   7. Connect the No. 1 fuel vapor feed hose to the intake manifold.

   8. Install the wire harness clamp bracket with the engine cover joint.

      10 N*m

      102 kgf*cm

      7 ft.*lbf

   9. Connect the wire harness clamp to the intake manifold.

   10. Install the wire harness clamp bracket with the bolt.

       15 N*m

       153 kgf*cm

       11 ft.*lbf

   11. Engage the 4 wire harness clamps.

3. INSTALL THROTTLE BODY ASSEMBLY

   Click here